The distribution box is basically used in every household. The distribution box at home is generally used to control the lighting system and socket, also known as the lighting box. For example, when you just move into a new home, some of them install the distribution box by themselves. If they install the distribution box by themselves, there is still some work to do before installation, which is the production and processing of the distribution box panel. Generally, most of the materials on the market are steel plates. Now let's take steel plate as an example to talk about the process of making distribution box panel assembly wiring!

First, the size of the steel plate needs to be good. When measuring, draw a line on the steel plate, and then cut it well. After cutting, use a file to change the corners. When the material is finished, the wiring starts. Remember to leave a gap between the panel and the box to facilitate the installation. Put the disk flat, and arrange the related things. First of all, pay attention to the drawings, select the best position to meet the requirements of the spacing, and ensure convenient operation and maintenance and beautiful appearance. After that, according to the actual position of your row, I have a good idea of how to play the relevant outlet, and paint the outlet after it is finished.

Then the incoming line appeared. First, put the porcelain tube head or rubber sheath on the inlet and outlet to maintain the wire, then put all the electrical appliances in place according to the set position, and fix them with wood screws or bolts. The thread should be tied neatly. Don't make it messy and uncomfortable for people to see. Tie it up one by one with a tie and fix it firmly with a clip. The zero bus of the neutral system is usually the terminal board of the zero line to lead and stop the branches or equipment. When the paint is dry, install the insulating nozzle, level all electrical components and instruments, and fix them firmly with screws. According to the specification, capacity and location of electrical components and instruments, the cross-section and length of the conductor shall be selected and cut for assembly. After the coil, the wires should be arranged in order. When pressing the head, the wires should be left with corresponding margin, and the outer skin should be peeled off and pressed one by one. If it's multi strand, you have to use crimp terminals. Well, the next step is to fix the installation, first fix the panel and fix the box, then fill the periphery with cement mortar and level it, and wait for the cement mortar to dry on the installation panel. If the bottom of the box is flush with the external wall, the wall plastering shall be done after the metal mesh is fixed on the external wall. Plastering shall not be carried out on the bottom of the box. The installation panel surface should be flat, the peripheral gap should be even and symmetrical, the face (door) should be flat and not inclined, the screws should be vertical and stressed evenly, and then the wiring should be carried out.